![]() ![]() The problem only seems to occur when playing low frequencies (bottom string) through the amp.Ĭontour is off & all tone controls are set mid way.So you already spent a lot of money and the problem is still there. The sine wave from the bass is good both at low and high frequencies. Running a tone generator into it produces a clean wave at 100hz & 1khz. I have already replaced the speakers (last post was a follow up from a month or two ago) and am having the same problem.Ĭontour is off & all tone controls are set mid way. ![]() If it's OK, you can verify the amp with external cab (you can borrow it instead of buying new speakers). Before you start replacing speakers you have to verify the amp. ![]() The signal looks like this because the input is not sinusoidal wave and maybe tone controls are not set to the middle position. The proper way to check the amp is to use a tone generator and a dummy load. A symmetrical sinewave sounds like cheap keyboard. If anyone has similar configuration - I'd welcome your comments on which way to go. Which would allow me to run the full 300w of the amp into the combo speakers.Īny pointers welcome, replace the speakers + leave room for an extension cab in the future or is it not worth it & should I replace the speakers and forgo the option of an extension cab in the future. Replace the existing speakers (Eminence LEGEND BP102 (8Ohm 200w) wired in parallel to drop the total load to 4Ohms. Replace the existing speakers (have seen some Eminence LEGEND BP102-4 (4Ohm 200w) which look like would make good replacements and still leave room for an extension cab later on if I wanted.Ĭ. Add an extension cab (not sure if I want to add an extra cab at this stage as the amp should be capable of delivering more power before the speakers start breaking up as it is) + it's heavy enough as it is.ī. If the existing speakers are breaking up at half volume, what route should I take:-Ī. So I'm wondering what to do as in my opinion, the built in speakers should be easily powerful enough to handle the 180watts the amp is advertised to deliver into 8Ohms at just about any volume + when plugging in an extra cab (1x15 or 2x10) to take the load down to 4Ohms, the amp should then be capable of delivering it's full 300watts. It's fine at lower volumes - just the attack when turned up. My problem is that whenever I play it at half volume (or more) the speakers start popping when I pluck the strings. It's rated at 300w into 4Ohms, has built in 2 x 10" speakers (total 8 Ohm load) and a spare jack on the back for an extension cab. I have a Gallien Krueger Backline 210 combo (bought late last year when I downsized my full rig to something more transportable). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |